Twister Trimmer T4
Part Number: 24-9019-00-P
- Throughput Wet: 23lbs/hr
- Throughput Dry: 16lbs/hr
- Weight: 56 lbs
- Dimensions: 25"L x 15"W x 16.5"H
- Input Voltage: 115V, 60Hz
- Current Draw: 2.5A
- Circuit Breaker Required: 15A / 120V
- Tumbler Slots: 40 x .25"
- Tumbler Diameter: 5in
- Cut Height: .040"
- Discharge: 5"
The Twister T4 is manufactured of lightweight anondized aluminum and stainless steel to deliver heavyweight results in any sized medical cannabis production.
Assembles quickly without any required tools and tears down in 15 secs.
T4 Dry Trimming
When trimming dry, ideally you’ll want to trim your flower at a moisture level between 10-11%, where the outside material of your flower is dry but the inside is spongy moist. How to test? Lightly squeeze the bud between your thumb and finger. If it crumbles, the product is too dry. If it stays squeezed it’s too moist. If it bounces back, it’s just right!
When trimming dry, you’ll want to remove any fan leaves and larger leafy material before you hang dry your product. Dry at 78-80 degrees F with a humidity level of approx. 62%. After you’ve reached your desired moisture level, buck the product off the plant and cut the stems as close to the flower as possible. Why? Stems can cause the flower to “pole vault” within the tumbler, reducing the chances the leaf will gain access to the blades. Removal of excess material will help produce a better final product and speeds up your trim time.
T4 Wet Trimming
When trimming dry, you’ll want to remove any fan leaves and larger leafy material before you hang dry your product. Dry at 78-80 degrees F with a humidity level of approx. 62%. After you’ve reached your desired moisture level, buck the product off the plant and cut the stems as close to the flower as possible. Why? Stems can cause the flower to “pole vault” within the tumbler, reducing the chances the leaf will gain access to the blades. Removal of excess material will help produce a better final product and speeds up your trim time.
When trimming dry, you’ll want to remove any fan leaves and larger leafy material before you hang dry your product. Dry at 78-80 degrees F with a humidity level of approx. 62%. After you’ve reached your desired moisture level, buck the product off the plant and cut the stems as close to the flower as possible. Why? Stems can cause the flower to “pole vault” within the tumbler, reducing the chances the leaf will gain access to the blades. Removal of excess material will help produce a better final product and speeds up your trim time.
- Food-grade stainless steel bearings
- Double sealed bearing chamber
- Maintenance free bearings
- Welded stainless steel tumbler end caps
- High air flow guard
- 304 stainless steel tumbler to mitigate the risk of contamination
- Nitrided steel blades increase strength and resistance and decrease buildup
- Commercial dishwasher safe
- Dire high pressure washing
