Twister Trimmer T2

The T2 Trimmer is built with for consistency, durability and reliability that medium to large scale producers require.  Installed in over 24 countries, the T2 Trimmer trims 35lbs/hr wet and 11lbs/hr dry.  This unit is easily scaled up to meet your harvest needs by linking and adding units to achieve your throughput needs.

Lightweight and 100% watertight, the T2 Twister Trimmer meets the demands of medical cannabis facilities. 

Dry Trimming with Twister T2

When trimming dry, ideally you’ll want to trim your flower at a moisture level between 10-11%, where the outside material of your flower is dry but the inside is spongy moist. How to test? Lightly squeeze the bud between your thumb and finger. If it crumbles, the product is too dry. If it stays squeezed it’s too moist. If it bounces back, it’s just right!

When trimming dry, you’ll want to remove any fan leaves and larger leafy material before you hang dry your product. Dry at 78-80 degrees F with a humidity level of approx. 62%. After you’ve reached your desired moisture level, buck the product off the plant and cut the stems as close to the flower as possible.

Wet Trimming with Twister T2

When trimming wet, you’ll want to trim your flower soon after it is bucked off your plants. Water your plants 4-6 hours before your trim session and try to keep them cold prior to trimming. Why? Firm, spry leaves are easier to trim with an automated trimmer. Wilted leaves can often wrap around the flower, contributing to a decline in overall performance.

When trimming wet, you’ll want to remove any fan leaves and larger leafy material before loading into your T2. This includes cutting stems close to the flower. While it is possible to trim everything on the plant with the T2 results may vary. Why? Larger material tends to wrap around the flower reducing the chances the leaf will gain access to the blades. Removal of excess material will help produce a better final product and speeds up your trim time.